KraftMaid Construction in Coral Springs, FL

KraftMaid Construction in Coral Springs, CA | Barrett & Sons Construction

We’re Barrett & Sons Construction, and we provide independent KraftMaid cabinet and kitchen construction service across Coral Springs. What makes our KraftMaid work different here comes down to one thing: we know Coral Springs’ deed-restricted neighborhoods and the ARC approval process inside out, so your cabinet project doesn’t stall for 60 days on paperwork. Tom Barrett grew up in the San Fernando Valley and learned framing at LA Trade-Tech before spending two decades building across Los Angeles, and he brings that same hands-on standard to every KraftMaid job we take on. Call (877) 610-1318 for a free estimate on your KraftMaid kitchen work, and we’ll walk you through what your specific neighborhood will require.

Call (877) 610-1318

Why Coral Springs Residents Choose Us for KraftMaid Service

We’ve reworked and installed Kraftmaid in Pompano Beach and across Coral Springs’ CBS homes for over a decade. That includes replacing water-damaged sink bases in 1980s kitchens and refacing entire cabinet runs for resale. We know the hinge, shelf-pin, and finish issues specific to KraftMaid’s Vantage, Passport, Durham, and Lexington lines in this climate, and we’re an independent shop, not a manufacturer-authorized dealer. Being independent means we answer to you, not to a corporate brand rep. Tom Barrett’s name, address, and license number are published and verifiable, and his sons run the crews on most days. That’s the kind of accountability you want when someone’s cutting into your kitchen walls.

KraftMaid cabinets show up in a lot of Coral Springs kitchens built between the late 1980s and mid-1990s. We’ve been inside enough of them to know what fails here and what holds up. Our KraftMaid sales & service experience covers everything from single-door hinge repairs to full kitchen remodels, and we bring OEM KraftMaid parts when they’re available. For parts that KraftMaid has discontinued, we source quality aftermarket hardware from Blum and Salice so the fit stays clean and the doors close right. Every estimate is free, every scope change arrives as a written change order before work begins, and every job carries our 90-Day Done Right Promise.

Common KraftMaid Construction Problems We Solve in Coral Springs

KraftMaid cabinets are solid when they’re installed right, but Coral Springs’ climate and housing stock create predictable failure patterns. Here’s what we see most often in our Coral Springs service area:

• Thermofoil delamination on Passport and Durham doors. The thermofoil door and drawer fronts on older Passport and Durham lines peel and bubble after years of South Florida humidity. It’s worst on west-facing walls where afternoon sun hits through original aluminum single-pane windows and bakes the adhesive layer. Once peeling starts, it won’t stop. We steer homeowners toward refacing or replacement rather than chasing peeling surfaces.
• Particleboard swelling behind sink bases and dishwashers. Coral Springs sits on former Everglades flatland with a seasonally high water table. Moisture wicks up through slab foundations, and particleboard side panels and toe kicks absorb it. We regularly see sink bases that crumbled behind the false drawer front, especially in homes built before vapor barriers became standard practice in the early 1990s.
• Rusted nickel hinges on Vantage and Passport lines. The nickel-plated hinges on those lines pit and rust in the coastal-adjacent humidity common to western Broward County. Once the plating goes, screws strip out and doors sag. We swap in new OEM hinges when available, or Blum soft-close hardware when KraftMaid has discontinued the original.
• Drawer glides gone bad in 1990s kitchens. Original mid-1990s KraftMaid glides lose their ball bearings after 30-plus years, especially in the pots-and-pans drawer under the cooktop. Matching replacements to older slide profiles matters more than most people expect, and we’ve got the patience to do it right.
• Out-of-square cabinet boxes after years of humidity cycling. CBS block homes hold humidity differently than wood-frame construction, and cabinet boxes that have cycled through 30 years of wet summers can shift enough that doors no longer align. We check the box before we hang the door, because hanging a new door on a twisted box just wastes your money.

KraftMaid Service in Coral Springs: What Local Conditions Mean for Your Equipment

Here’s the thing about KraftMaid work in Coral Springs that most out-of-town crews don’t know until it bites them. Coral Springs was master-planned and built out almost entirely between the late 1960s and mid-1990s by Coral Ridge Properties as a deed-restricted community. Nearly every neighborhood operates under deed restrictions inherited from that original master plan. That means exterior-affecting construction, even something as small as adding a kitchen exhaust vent or enlarging a window opening for a new cabinet run, requires HOA architectural review committee sign-off before you can pull a Broward County permit. The ARC review takes 30 to 60 days, and it’s a dual-track process: first the HOA, then the county. We factor that delay into every Kitchen Remodeling - Coral Springs and bath remodel timeline here, which sets us apart from crews used to quicker Broward County jurisdictions. It also means we plan cabinet work that touches exterior walls in stages so the ARC clock starts early. If you’re in a neighborhood like Cypress Run or any of the original Coral Ridge Properties phases, expect that review. We handle it as a matter of course, not as a surprise.

One more local factor worth knowing: the seasonally high water table here means any below-grade work near your kitchen, like moving a sink drain line or adding a dishwasher rough-in, hits standing groundwater fast. We coordinate with South Florida Water Management District drainage easements when the job calls for it, which most cabinet installers never mention until the county flags it.

KraftMaid Models & Products We Service in Coral Springs

We work on the KraftMaid lines most common in Coral Springs homes: Vantage, Passport, Durham, and Lexington. That covers everything from early Passport cabinets in late-1980s builds to Durham and Lexington runs from the mid-1990s and later. For parts, we use OEM KraftMaid hinges, glides, and shelf clips when they’re available and quick to source. When KraftMaid has discontinued a part or lead times stretch past what any reasonable homeowner should wait, we install quality aftermarket hardware, most often Blum or Salice soft-close glides and hinges, that fit the original profiles. We keep common hinge overlays and shelf pin styles stocked locally so most Coral Springs cabinet repairs don’t wait on a parts shipment from Ohio.

KraftMaid Service Pricing in Coral Springs

FAQs - KraftMaid Construction in Coral Springs

Can you match the original 1980s KraftMaid Passport door style when refacing only part of my Coral Springs kitchen? We can match the door profile and finish closely, and in some cases exactly, but 1980s thermofoil colors shift over time, so a perfect seamless match on a partially refaced run is rare. We’ll show you samples from the current Passport and comparable profiles and tell you honestly whether the match will pass from five feet away. When it won’t, we’ll recommend refacing the full run. Call (877) 610-1318 for a free in-home assessment.

How do Coral Springs’ building permit requirements affect a cabinet-only KraftMaid installation? A cabinet-only swap with no change to plumbing, electrical, or exterior walls typically doesn’t need a Broward County permit. If the work touches exterior walls, adds an exhaust vent, or moves a sink or dishwasher line, it does. And if your neighborhood is under original Coral Ridge Properties deed restrictions, the HOA ARC may need to review the work even when the county doesn’t. We tell you which applies to your specific street before we start.

Is it worth replacing just the thermofoil doors on my peeling KraftMaid cabinets, or do I need full refacing? Replacing only the doors when the thermofoil is peeling usually wastes money, because the box faces and side panels often start delaminating next, and the sheen won’t match. For cabinets where the boxes are structurally sound, refacing with new doors, drawer fronts, and veneer on the exposed boxes gives you a durable result without tearing out sound boxes. We’ll show you both options and the price difference in writing.

Can you retrofit soft-close hinges and drawer glides onto my 1990s KraftMaid cabinets without replacing the boxes? Yes, in most cases. Blum and Salice make retrofit hinge and glide kits that fit the standard KraftMaid overlays and drawer profiles from the 1990s. If your existing boxes are square and the side panels aren’t swelling, retrofitting is a cost-effective upgrade. If the boxes have moisture damage from Coral Springs’ high water table, retrofitting onto them just postpones the real problem. We’ll inspect before we quote.

Does the high water table in Coral Springs affect KraftMaid cabinet installation near sinks and dishwashers? Yes, and it’s one of the first things we check. Particleboard box cabinets sitting directly on slab foundations can wick moisture during the seasonal water-table rise, especially behind sink bases and dishwashers. We use moisture barriers and shim materials rated for slab contact on installations where the original build didn’t include them. For refacing jobs where the boxes have already absorbed moisture, we’ll tell you if replacement is the smarter spend. Call (877) 610-1318 for an exact quote, and we’ll come look at your cabinets in person.

Service Areas Near Coral Springs

Our KraftMaid construction service covers Coral Springs and nearby communities across Broward and Miami-Dade. You’ll find us working regularly in KraftMaid service in Miramar and KraftMaid service in Fort Myers. If you’re just outside Coral Springs, call and ask. Tom answers his own phone, and if the job’s a good fit, we’ll come out.

Book Your KraftMaid Service in Coral Springs Today

If your KraftMaid cabinets need repair, refacing, or a full replacement in Coral Springs, call (877) 610-1318 to schedule your free estimate. We’ll walk through what your HOA requires, what the permit situation looks like, and what the job will cost in writing. We’ll do it right the first time, or we’ll come back and make it right.

Written by Tom Barrett, Owner at Barrett & Sons Construction, serving Coral Springs since 1998.