Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Fast, Reliable Kitchen Remodeling Across Sierra Madre
Kitchen remodeling in Sierra Madre runs $14,000-$45,000 for a full tear-out and rebuild, with smaller galley or partial remodels landing between $9,000 and $20,000. That’s the honest range we quote in this foothill market, where fault setbacks, fire-code upgrades, and historic-designation reviews change the scope before the first cabinet comes down. We’re Barrett & Sons Construction, and we’ve been pulling permits and writing change orders in communities like this since 1998. If you’re weighing a remodel on a Craftsman near Baldwin Avenue or a ranch home up toward the canyon, call Tom at (877) 610-1318 for a free estimate and a walkthrough that starts with the site plan, not the showroom.
Why Barrett & Sons Construction Is Sierra Madre’s Preferred Kitchen Remodeling Company
What separates a good kitchen remodel in Sierra Madre from a stalled one is knowing which reviews apply before you start swinging hammers. We pull permits on every eligible job. That means the Sierra Madre Fault setback check, the Chapter 7A fire-standard review for homes in High Fire Hazard Severity Zones, and the Historic Preservation Commission sign-off for pre-1940 structures. Most contractors find out about these constraints when the City rejects the plan. We plan for them on day one.
Tom Barrett puts his name, his license number, and his address on every contract. You can look him up. His sons run the crews. That’s not a marketing line, it’s how we’ve operated since 1998. When a Sierra Madre homeowner calls about a load-bearing wall or an island footprint that conflicts with a mapped fault zone, Tom is the one who calls back, not a call center.
Sierra Madre customers also get the same standing offers we publish everywhere: $40 off any repair over $200, a free second opinion on any written estimate, no trip charge inside Los Angeles County, and a permanent 10% senior and veteran discount. Plus the 90-Day Done Right Promise, written into every contract. If something’s not right after we finish, one call brings Tom back.
Our Kitchen Remodeling Services in Sierra Madre
Every kitchen we build in Sierra Madre starts with the same question: what does the City need to see before we order a single cabinet? Here’s what we cover for homes across 91024 and 91025.
Full Kitchen Remodeling
A full kitchen remodel in Sierra Madre means gutting down to studs, relocating plumbing and electrical, redoing drywall, flooring, cabinets, counters, lighting, and ventilation. It also means documenting every structural change. On hillside lots below Winter Creek drainage, that can include deeper foundation checks and engineered beams for wall removals. Our Kitchen Remodeling team handles the whole scope, permits through final inspection.

Kitchen Design & Layout
Here’s where Sierra Madre stands apart from flat-grid neighbors like Arcadia or Monrovia. A proposed island footprint can conflict with a mapped Sierra Madre Fault setback zone, which means the City won’t issue the building permit until the layout changes. We run a site plan check before we ever show you a rendering. That way your island, range wall, and peninsula land where the fault setback allows, not where the national design software defaults them.

Cabinets & Countertops
We install KraftMaid cabinetry and Cambria and quartz or granite counters, chosen because the product specs are published and verifiable, not mystery brands off a van. In Sierra Madre’s older homes, cabinet installation often reveals uneven framing from a century of settling. We shim and scribe to the actual wall, not the drawing, so doors close square and drawers slide true. Expect cabinet work to run $4,000-$13,000 and countertops $2,000-$6,500.

Backsplash, Tile & Flooring
Backsplash installation in Sierra Madre typically runs $800-$2,500 depending on material and square footage. For homes in the Wildland-Urban Interface, we use non-combustible tile directly behind the range wall and avoid combustible wainscoting where code restricts it. Floor tile gets set on cement board over the existing subfloor, leveled to handle the modest differential settlement common in foothill homes built between the 1890s and 1940s.

What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Trusted Brands We Service in Sierra Madre
We install named brands you can research before you sign: KraftMaid and Cambria in kitchens, PGT and Simonton on windows, GAF and CertainTeed on roofs. For Sierra Madre kitchens specifically, we stock ember-resistant vent models and ignition-resistant backer board locally, which keeps turnaround tight when a Chapter 7A inspection calls for a swap. We don’t use mystery products from a warehouse you’ll never see, and we list every material on your written scope with allowance amounts.
Common Kitchen Remodeling Problems We See in Sierra Madre Homes
Sierra Madre’s housing stock is not like the track homes down in the flats. Here’s what we run into on a regular basis:
- Fault setback conflicts discovered after demo. You tear out a kitchen in a 1920s Craftsman, the City flags the island footprint against a mapped Sierra Madre Fault zone, and the job halts. We run the site plan check first so this does not happen mid-project.
- Chapter 7A fire-code failures. Standard range hood vents or combustible cladding behind the range wall pass in Arcadia. In Sierra Madre’s High Fire Hazard Severity Zone, the inspector fails you and a change order lands in your lap. We spec ember-resistant vents and non-combustible cement board from the first quote.
- Unreinforced masonry chimneys behind kitchen walls. Many pre-1940 Sierra Madre homes have brick chimneys that were never reinforced. Cut into one without a structural review and the Historic Preservation Commission can issue a stop-work order. We inspect before we cut.
- Load-bearing wall removals without documentation. You remove a wall to open the kitchen, skip the engineered beam spec or the inspection sign-off, and later an earthquake or windstorm damages the space. Your insurance carrier can deny the claim. We document every beam, every calc, and every sign-off.
Trusted Brands We Service in Sierra Madre
We install named brands you can research before you sign: KraftMaid and Cambria in kitchens, PGT and Simonton on windows, GAF and CertainTeed on roofs. For Sierra Madre kitchens specifically, we stock ember-resistant vent models and ignition-resistant backer board locally, which keeps turnaround tight when a Chapter 7A inspection calls for a swap. We don’t use mystery products from a warehouse you’ll never see, and we list every material on your written scope with allowance amounts.
Pricing for Kitchen Remodeling in Sierra Madre, CA
Here’s what a Sierra Madre kitchen remodel actually costs, line by line, based on current local material and labor rates across 91024 and 91025:
| Line Item | Typical Sierra Madre Range |
|---|---|
| Full Kitchen Remodel | $14,000-$45,000 |
| Small Kitchen Remodel | $9,000-$20,000 |
| Cabinet Installation | $4,000-$13,000 |
| Countertop Installation | $2,000-$6,500 |
| Backsplash Installation | $800-$2,500 |
| Kitchen Island Installation | $3,000-$10,000 |
What moves a Sierra Madre job from the bottom to the top of those ranges? Fault setback reviews, Chapter 7A-compliant vents and cladding, historic preservation sign-offs, and the structural engineering for load-bearing wall removal. A cheap quote skips these. Then the City catches it, and the cheap quote becomes a costly correction. Call (877) 610-1318 for a free estimate that includes the line items that actually matter in this city.
We Also Serve Cities Near Sierra Madre
Our crews work locally in Sierra Madre and the surrounding foothill communities, including Arcadia, East Pasadena, Mayflower Village, and Monrovia. Same owner-operated crew, same written change orders, same 90-Day Done Right Promise. If you’re in a neighboring ZIP and wondering whether the fault setback or fire-code rules apply to your street, call us. We’ll tell you straight.
Serving Sierra Madre, CA - Our Local Coverage Area
We’re based in the Sierra Madre area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs - Kitchen Remodeling in Sierra Madre
Yes. Because the Sierra Madre Fault traces directly beneath parts of the city, the building permit process includes a review of any proposed structure footprint against mapped fault setback zones. That means your island, peninsula, or extended wall footprint may need to be redesigned before the City issues a permit. We run the site plan first, so you’re not redesigning after demo. Call (877) 610-1318 for a free estimate that includes the setback check.
In High and Very High Fire Hazard Severity Zones, Chapter 7A applies to any major remodel touching exterior-facing components: ember-resistant vents, ignition-resistant cladding on exterior walls, tempered glazing on windows, and non-combustible materials directly behind the range wall in many cases. A compliant quote includes these line items. A cheap one leaves them out and lets the inspector find them. That’s a change order with your name on it.
Historic Preservation Commission review is required for most exterior and some interior changes on locally designated properties. Interior kitchen work often proceeds with standard permits, but any change to window openings, exterior venting, or visible structural elements may need HPC sign-off first. We’ve pulled permits here long enough to know which projects trigger review, and we schedule that early rather than waiting for a stop-work order. Call (877) 610-1318 if you’re unsure where your home falls.
Keep the engineered beam calculations, the permit, and the inspection sign-off. All three. If you remove a load-bearing wall without documentation and a seismic event or Santa Ana wind event damages the kitchen, your carrier can deny the claim on the grounds of unpermitted structural alteration. We provide every calc, every permit, and every sign-off on paper before we close up the wall.
Everything. Every allowance, every scope item, every wind-load upgrade, every ember-resistant vent model, every price change. An allowance that isn’t on paper is a surprise waiting for a date. We issue written change orders before any scope change touches the job. If it’s not in writing, it didn’t happen. Call (877) 610-1318 to get a written scope on your Sierra Madre kitchen.
Written by Tom Barrett, Owner at Barrett & Sons Construction, serving Sierra Madre since 1998.







Before
After
Before
After
Before
After