Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Before
After
Before
After
Before
AfterFast, Reliable Fence Installation Across Whittier
Fence installation in Whittier typically runs $3,500 to $9,000 for wood or vinyl, and $4,000 to $10,000 for aluminum, with wind-engineered footings adding $800 to $2,500 depending on your lot. We build fences that survive Santa Ana wind events, not fences that look good for two years and shear off at the base. Barrett & Sons Construction has been owner-operated since 1998, and Tom Barrett’s sons run the crews that work Whittier neighborhoods every week. Call (877) 610-1318 for a free written estimate, with no trip charge inside the county.
Why Barrett & Sons Construction Is Whittier’s Preferred Fence Installation Company
We’re the crew your neighbors already know. Tom Barrett founded this company in 1998, and his name, address, and license number are published for anyone to look up before they sign a contract. That’s not an accident. When you live twenty minutes from the job site, you answer the phone differently. You show up differently. You stand behind the work differently.
Friendly Hills, Whittier Hills, Uptown, the flatland tract streets south of Whittier Boulevard: we’ve pulled permits and passed inspections in every corner of this city. Our crew members are background-checked and carry the Barrett & Sons name on their uniforms. If something’s not right after the job, our 90-Day Done Right Promise is written on the contract, not buried in fine print. One call brings Tom back.
We answer our own phone, 24/7. Not a voicemail box, not an out-of-state call center. When you call (877) 610-1318, a live person picks up.
Our Fence Installation Services in Whittier
Wood Fence
Redwood and pressure-treated pine remain the most common fence materials in Whittier’s older neighborhoods, but the way they’re built matters more than the board you pick. Original 1960s redwood fences around Uptown and the 90601 ZIP were installed without gravel drainage or post caps, so they rot from the inside out, usually inside fifteen years. We set pressure-treated posts in 30-inch pier holes with compacted aggregate backfill and hot-dip galvanized hardware, so water doesn’t pool at the post collar. If you’re replacing an old redwood fence near Whittier Boulevard, expect to spend $3,500 to $9,000 depending on linear footage and whether we’re hauling away the old posts.
Aluminum Fence
For hillside lots in Friendly Hills and Whittier Hills, aluminum is often the smartest choice. It doesn’t rot, it doesn’t warp, and it doesn’t snap under wind load the way a 4×4 post does. Wind gusts over 70 mph are a regular event in those neighborhoods, and an aluminum rail panel that weighs a fraction of a wood section still needs proper anchoring. We engineer the post footings for wind load, with rebar cages and deeper piers than the inland standard. Aluminum fence installation in Whittier runs $4,000 to $10,000.
Vinyl Fence
Vinyl holds up well in Whittier’s dry inland climate, and unlike wood, it won’t absorb rain and swell against the brackets. But cheap vinyl panels flex and crack under sustained Santa Ana gusts, especially on exposed ridgelines. We use heavier-gauge vinyl with reinforced bottom rails and set posts deeper than code minimums where wind exposure is a factor. Vinyl fence installation in Whittier typically runs $3,500 to $9,000, and the price difference between a basic vinyl fence and a wind-engineered one is usually around $1,000 to $1,800 on a standard lot.
Fence Repair
Most fence repair calls we get in Whittier are the same story: a post snapped at ground level, or a gate that won’t close because the post has drifted out of plumb. Clay soil in the 90603 ZIP expands and contracts with seasonal rain, slowly levering posts over and cracking the concrete collars. We fix the footing, not just the board. A repair often means pulling the old post, drilling a deeper pier, and resetting it with compacted aggregate and a rebar cage, so it doesn’t lean again in two years.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Trusted Brands We Service in Whittier
We don’t install mystery brands off a van. When the job calls for it, we specify materials from Techo-Bloc, Quikrete, and Cambridge Pavers for fence footings, post bases, and adjacent hardscape. That matters in Whittier because the same clay and wind conditions that stress your fence also stress the concrete that holds it. We keep common Quikrete products and hot-dip galvanized brackets in stock for Whittier jobs, which means fewer runaround days and a faster start on your fence replacement. If you want to look up what’s going into your yard before we start, we’ll tell you the brand and the product number.
Common Fence Installation Problems We See in Whittier Homes
- Posts sheared at ground level after Santa Ana events. Up in Friendly Hills we replaced a 1970s redwood privacy fence that had sheared off at the post bases after a December Santa Ana event. The original posts were set in 18-inch concrete but had no rebar cage, and the continuous gusts cracked every footing at grade. We pulled new permits, dug 30-inch pier holes, and set pressure-treated posts with hot-dip galvanized brackets and #4 rebar before backfilling with compacted aggregate. The inspection sign-off confirmed wind-load capacity for sustained 80 mph events.
- Clay soil levering posts out of plumb. Whittier’s cut-and-fill hillside lots hold expansive clay that swells with winter rain and shrinks in summer. That seasonal movement works fence posts like a loose tooth, cracking concrete collars and leaving gates that won’t latch by August.
- Original redwood fences rotting from the inside out. Homes built in the 1950s and 1960s across Whittier’s southern tract neighborhoods got fences installed without post caps or gravel drainage. Water sits at the base, wicks up through the end grain, and the posts rot invisibly until a windstorm finishes the job.
- Galvanized hardware rusting at every fastener. Whittier sits at the inland edge of the San Gabriel Valley foothills, but the air still carries enough moisture to corrode standard galvanized fasteners over a decade. We use hot-dip galvanized or stainless hardware on every fence we build here, because a fence that falls apart at its screws is a fence you pay for twice.
Pricing for Fence Installation in Whittier, CA
Whittier fence pricing breaks down into three main buckets. Wood fence runs $3,500 to $9,000, aluminum fence installation runs $4,000 to $10,000, and vinyl fence installation runs $3,500 to $9,000. Linear footage drives the base price; wind exposure, soil condition, and whether we’re removing an old fence drive the rest.
| Fence Type | Typical Whittier Price Range |
|---|---|
| Wood Fence | $3,500 - $9,000 |
| Aluminum Fence Installation | $4,000 - $10,000 |
| Vinyl Fence Installation | $3,500 - $9,000 |
A basic wood fence on a flat lot in the southern tract ZIP codes of Whittier lands at the lower end of that range. A wind-engineered aluminum fence on an exposed Friendly Hills ridgeline lands at the upper end, because the footings are deeper, the rebar cages are larger, and the inspection sign-off covers wind-load capacity. That’s the difference between a fence that stands for thirty years and one that shears off in the first big blow. Every estimate from Barrett & Sons is written, line by line, and any price change arrives as a written change order before work starts. Call (877) 610-1318 to schedule a free estimate.
We Also Serve Cities Near Whittier
Our Fence Installation team works throughout Whittier and the surrounding communities: South Whittier, West Whittier-Los Nietos, East La Mirada, and Santa Fe Springs. If you’re just outside the city line, call (877) 610-1318 and ask about coverage. We coordinate scheduling from our Los Angeles office, and crews serve Whittier locally. For more on the work we do across the region, see our Fence Installation in Whittier page.
Serving Whittier, CA - Our Local Coverage Area
We’re based in the Whittier area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs - Fence Installation in Whittier
Yes, most fence installations in Whittier require a permit, and the inspection sign-off covers post depth, footing construction, and wind-load anchoring where applicable. We pull the permit, we schedule the inspection, and we don’t ask you to handle any of it. The permit inspector works for you, not for me, and that’s exactly why we want them on site. Call (877) 610-1318 for a free estimate, and we’ll tell you exactly what your Whittier property needs before any work begins.
Wood fences in Whittier rot faster than in Norwalk because the city sits at the inland edge of the San Gabriel Valley foothills, where wind-driven moisture and seasonal clay movement combine to stress posts at the base. Norwalk is flat and drier, with less wind exposure. Whittier’s hillside neighborhoods also concentrate runoff, so water pools around post collars and works its way up through the end grain. We build against that with gravel drainage, post caps, and pressure-treated or hot-dip galvanized hardware. The upfront cost is slightly higher; the lifespan is double. Call (877) 610-1318 to get a written quote for your street.
Aluminum survives Santa Ana winds better than wood in Friendly Hills, because aluminum rail panels flex without snapping and weigh far less than a solid wood section. But the post footings matter more than the panel. A wood fence with engineered 30-inch piers and rebar cages will outlast a cheap aluminum fence set in 18 inches of unreinforced concrete. We specify both materials for Whittier hillside lots, and we engineer the footing for sustained 80 mph wind load. Call (877) 610-1318 and we’ll look at your exact exposure before recommending one over the other.
The realistic price difference in Whittier is $800 to $2,500 depending on your lot. A basic wood fence on a flat street in the 90601 ZIP might run $3,500 to $5,500. The same fence on an exposed Friendly Hills ridgeline with 30-inch piers, rebar cages, and a wind-load inspection sign-off runs closer to $6,500 to $9,000. That extra money buys a footing that won’t crack at grade in the first December wind event, which is the failure we replace most often. Call (877) 610-1318 for an exact written quote, free.
The Whittier Fault runs directly through the city, and while a fence footing is not a seismic retrofit, the same ground movement that stresses foundations also stresses fence posts and retaining wall junctions. We see cracks and lateral displacement concentrated where fences tie into retaining walls on hillside lots, especially in the 90603 and 90605 ZIP codes. When we build in those areas, we isolate the fence footing from the wall with expansion joints and set posts deeper than standard, so the two structures move independently instead of fighting each other. Call (877) 610-1318 to have us look at your property line.
Get a Free Fence Installation Estimate in Whittier
You deserve a fence that stands through the next Santa Ana season and the one after that. Call Barrett & Sons Construction at (877) 610-1318 for a free written estimate, with no trip charge inside the county. We’ll walk your property line, measure your exposure, and give you a line-by-line quote before you spend a dollar. Tom Barrett’s name and license number are published for anyone to verify, and our 90-Day Done Right Promise is written on every contract. Senior and veteran customers save 10% permanently. Call today.
Written by Tom Barrett, Owner at Barrett & Sons Construction, serving Whittier since 1998.