Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Before
After
Before
After
Before
AfterFast, Reliable Fence Installation Across Shafter
A new fence in Shafter typically runs $3,500 to $9,000 depending on the material, linear footage, and what’s underneath the topsoil. Most homeowners call us because their old fence failed at the post line, rotted out at the bottom rail, or was never built for wind that funnels off the open farmland west of Highway 99. We’re Barrett & Sons Construction, and we’ve been setting posts in Kern County soil long enough to know what holds and what doesn’t. If you’re in the 93263 zip code or anywhere around Shafter, call (877) 610-1318 and we’ll come out, walk the line with you, and give you a written quote before any work happens.
Why Barrett & Sons Construction Is Shafter’s Preferred Fence Installation Company
Tom Barrett started this company in 1998, and the name on the truck is the same name that answers the phone. When you call about a fence in Shafter, you’re not getting routed through a call center in another state. Tom or one of his sons picks up, asks where you’re located, and treats your project like it’s on his own street. That matters in a town like Shafter, where people still wave to their neighbors and expect a handshake to mean something.
Our Fence Installation team has set hundreds of posts in the expansive clay that runs under most of Shafter’s older subdivisions. That clay shifts. A lot. Posts that are set shallow or without proper concrete crown will heave within a few wet winters and leave you with a leaning fence line by spring. We dig deeper than code requires, crown the concrete so water runs away from the post, and use galvanized post bases on wood fences so the rot-prone part never touches soil. This is local knowledge, not something a national outfit’s estimator learns from a PDF.
Every job gets a written scope, a written price, and a written change order if anything shifts. The permit inspector works for you, not for me, and we pull permits on every eligible fence project in Shafter. If something’s not done right, the 90-Day Done Right Promise means one call brings Tom back. No games, no waiting on a “claims department.”
Our Fence Installation Services in Shafter
Wood Fence Installation in Shafter
Wood remains the most common fence we install in Shafter’s older neighborhoods, where mid-century homes on Mannel Avenue and Sunset Boulevard still wear the same cedar and redwood lines they’ve had for decades. We build with pressure-treated posts and kiln-dried rails, using post spacing that accounts for Shafter’s clay soil movement. A wood privacy fence in Shafter usually falls on the lower end of the $3,500-$9,000 range, depending on height and whether you want a board-on-board or shadowbox design.
Chain Link Fence Installation in Shafter
For rear property lines, dog runs, and commercial perimeter work near the BNSF intermodal facility or Airport Road, chain link is the practical choice. We install galvanized and vinyl-coated chain link, and we use the same deep-post standard on every line, because chain link leaning on a badly-set post looks just as tired as wood. Chain link is generally the most budget-friendly option for Shafter lots, and we’ll give you an exact number before a single post hole is dug.
Vinyl Fence Installation in Shafter
Vinyl has gotten popular in the newer subdivisions built since 2010 to house Shafter’s logistics workforce. It handles the summer heat without fading the way cheaper plastics do, and it doesn’t rot or splinter. The thing to watch is wind load. Out on the flat parcels west of 99 with nothing but almond orchards to brake the breeze, a vinyl fence without enough post depth will rack. We build vinyl lines accordingly, and the cost in Shafter typically lands in the mid-to-upper portion of that $3,500-$9,000 window.
Aluminum Fence Installation in Shafter
Aluminum is the pick for Shafter homeowners who want a clean, straight line around a pool enclosure or a front yard definition on the newer side streets. It’s rust-resistant, which matters in Kern County’s irrigation-heavy air, and it doesn’t warp like thin steel. Aluminum fence installation in Shafter generally runs $4,000 to $10,000 depending on panel height and gate hardware. We also build matching Driveway & Pavers in Shafter transitions so your fence line meets your hardscape cleanly.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Trusted Brands We Service in Shafter
We don’t put mystery materials off the back of a van on your property. For Shafter fence work, we stock and install hardware and materials you can look up: Belgard and Techo-Bloc post caps and hardscape transitions, plus quality-treated lumber milled for inland California climates. When a gate hinge fails or a post base needs replacement, having local stock means faster turnaround for our Shafter customers. If you’re also thinking about a paver walkway along your new fence line, we use Cambridge Pavers and Oldcastle products on Home Additions & ADU in Shafter and hardscape jobs across town.
Common Fence Installation Problems We See in Shafter Homes
- Clay soil heave at the post line. Shafter’s expansive clay absorbs winter moisture and swells, then shrinks hard in the 105°F summers. Shallow posts get pushed up and out of plumb within two or three seasons. We set posts below the frost line and deeper than clay’s active shrink-swell zone, then crown the concrete to shed water.
- Wind racking on flat, exposed lots. The open ground between Shafter and Wasco doesn’t slow the wind down much. Fences that look square on install day can rack out of square by October if the line wasn’t braced for sustained gusts. We use heavier corner posts and mid-run bracing on exposed sides.
- Rotted bottom rails from sprinkler overspray. Older Shafter irrigation systems throw water right onto the fence line. We see bottom rails turned to sponge in five years when they sit against wet soil. We gap the bottom rail and spec rot-resistant lumber where sprinklers run close.
- Gate sag on post-set hardware. The most common repair call we get in Shafter isn’t a full fence replacement; it’s a gate that drags across the concrete walkway. Post-mounted hinges pull out of soft or cracked concrete. We fix the post first, then the gate, and the fix holds because the post base is right.
Pricing for Fence Installation in Shafter, CA
Most fence installations in Shafter land between $3,500 and $9,000. Wood privacy runs on the lower-middle end of that range, vinyl and aluminum push toward the top, and a full property enclosure with multiple gates can cross $9,000 on larger corner lots. Chain link is the most budget-conscious option, and we’ll beat back any vague verbal estimate with a written line-item quote that shows exactly where your money goes. Material choice, linear footage, gate count, and what the post holes hit underground are what move the number. Call (877) 610-1318 for an exact quote on your Shafter property. Estimates are free, and the price on paper is the price you pay, because every change gets written before it’s done.
We Also Serve Cities Near Shafter
Our crews cover Shafter and the surrounding Kern County communities, including Rosedale, Greenacres, McFarland, and Wasco. If you live just outside town on a county parcel or in one of the newer subdivisions east of 99, we’ll come to you. Fence Installation in Shafter is our home base for this area, and the same crew that quotes your fence is the crew that builds it.
Serving Shafter, CA - Our Local Coverage Area
We’re based in the Shafter area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs - Fence Installation in Shafter
We can usually get a crew to a Shafter property within a few days of your call, and we answer the phone live around the clock. For repair work like a fallen gate or a section that came down in a storm, we’ll get you on the schedule as soon as physically possible. Call (877) 610-1318 and tell Tom what you’re dealing with, and you’ll get a straight answer, not a voicemail.
Yes. We cover the full 93263 zip code, from the older neighborhoods off Mannel Avenue to the newer subdivisions east of 99 and the industrial corridor along Airport Road. Commercial perimeter fencing near the BNSF intermodal facility and surrounding distribution centers is something we handle routinely, including the stricter grading and drainage requirements Kern County applies to those flat parcels.
Fence repair in Shafter can run anywhere from a few hundred dollars for a gate hinge or a section of rails to $2,500 or more for a failed post line that needs resetting. Full replacement usually starts around $3,500 and climbs based on material and footage. The cheapest fix isn’t always cheapest over time; if the posts are moving in clay soil, we’ll tell you straight whether repair makes sense or whether you’re throwing money at a failing line. The estimate is free either way.
We pull permits on every eligible fence project in Shafter. Kern County and the City of Shafter have specific fence height and setback rules, and we handle that paperwork before the first post hole is dug. The permit inspector works for you, not for me, and we like it that way. If a previous contractor told you permits were optional, they were wrong.
Shafter fence pricing is generally in line with the broader Kern County market, but you’ll sometimes pay less here than in Bakersfield proper because the drive is shorter and the soil conditions are consistent enough that we don’t have to price for unknown surprises the way we might on a hillside lot. Our $3,500-$9,000 range for Shafter holds steady for most residential work, and we’ll honor that range unless your project has something unusual, like significant old concrete removal. Call (877) 610-1318 for a written, line-item quote; nothing changes without a written change order.
Written by Tom Barrett, Owner at Barrett & Sons Construction, serving Shafter since 1998.