Ameristar Kitchen Remodeling Nationwide | Barrett & Sons Construction

Ameristar Kitchen Remodeling: The Los Angeles Owner’s Guide

Ameristar kitchen remodeling in Los Angeles typically runs $16,520 to $53,100 installed, depending on cabinet line, countertop material, and how much layout work the room needs. We stock Ameristar-compatible cabinet hardware, replacement doors, drawer glides, and hinge packs on our trucks, and we can usually match a failed part the same week. Most owners discover a problem the way you just did: a drawer sticks, a hinge sags, a door won’t close square, or a cabinet box starts pulling away from the wall after years of California dry heat and the occasional kitchen flood.

Call (877) 610-1318

Barrett & Sons Construction is an independent Los Angeles contractor. We are not affiliated with Ameristar, but we’ve installed and repaired their cabinet lines across the Valley, the Westside, and down into South LA for years, so we know which parts fail, which ones interchange, and which ones you should never try to save money on.

Key takeaways:

• Ameristar kitchen cabinets fail most often at hinges, drawer glides, and door alignment, rarely at the boxes themselves.
• OEM Ameristar parts are worth the cost on hinges and glides; aftermarket works fine for shelf pins and bumpers.
• Los Angeles heat and low humidity dry out wood and MDF faster than coastal climates, which is why doors warp and glides bind here more than people expect.
• Full Ameristar kitchen remodeling in Los Angeles starts around $16,520 and tops out near $53,100 when you’re moving walls, relocating plumbing, and upgrading to stone.

Which Ameristar Models This Applies To

Ameristar built cabinets under a few different series names over the years, and the part that fits a 2008 Ameristar Silverline box won’t always match a 2019 Ameristar Estate. The fastest way to identify what you have is to pull a drawer and look at the inside of the cabinet box for a printed label, usually white or silver, with a model number and a date code. If the label’s gone, measure the hinge cup: Ameristar used 35mm full-overlay hinges on most lines after 2012, but older boxes often ran 26mm or 32mm partial-overlay hardware, and that difference alone will send you home with the wrong part if you guess.

The compatibility gotcha we see most in Los Angeles: Ameristar finished panels are color-matched at the factory, and a “white” door from one production run can sit a half-shade off the “white” box from another. If you’re replacing a single door or drawer front, we always take a sample to match, because the kitchen light in a Sherman Oaks condo shows the difference instantly. For hinges and glides, OEM Ameristar is our default. For shelf pins, bumpers, and plastic corner braces, a quality aftermarket equivalent from Blum or Salice does the job and saves you real money.

Signs Your Ameristar Kitchen Remodeling Is Failing

• A drawer drags or binds halfway open. This is almost always a failed under-mount glide or a roller wheel that’s lost its bearing. In Los Angeles, heat hardens the nylon wheels faster, and once one binds, the drawer pulls the other side out of square.
• A door hangs low or won’t stay closed. The hinge spring is shot, or the mounting screws have stripped out of the particleboard. Ameristar hinges are not adjustable forever; once the spring goes flat, the door drops and the reveal goes uneven.
• A hinge screw keeps spinning without tightening. The cabinet box has lost its bite around the screw, often from years of opening and closing with the door slightly misaligned. We fix this with a proper dowel-and-glue fill, not by driving a bigger screw and hoping.
• The cabinet box pulls away from the wall. This is a mounting problem, not a cabinet problem, but it shows up on Ameristar installs where the original crew missed a stud. Left alone, the whole run can sag and crack finished panels.
• Doors or drawer fronts are warped at the edges. Los Angeles dry heat, especially in the eastern parts of the county, draws moisture out of MDF door cores. Once a door bows more than an eighth inch, no hinge adjustment will pull it flat.

Replacement Cost & What’s Included

Ameristar kitchen remodeling in Los Angeles carries a wide range because the job can mean anything from a single replacement door to a full gut-and-rebuild. Here’s how the numbers break down in this market:

• Full Ameristar kitchen remodel: $16,520-$53,100
• Small kitchen remodel, Ameristar cabinets kept or refaced: $10,620-$23,600
• Cabinet installation (new Ameristar boxes, labor only): $4,720-$15,340
• Countertop installation to match existing cabinets: $2,360-$7,670
• Backsplash installation: $945-$2,950
• Kitchen island installation: $3,540-$11,800

Every quote we write in Los Angeles includes parts, labor, haul-away of the old material, and a written change order if anything shifts after the estimate. You’ll see the line items before we start, and nothing gets added at the end that wasn’t on paper first. The work is covered by our 90-Day Done Right Promise: if something isn’t right, Tom Barrett comes back and makes it right, one call.

DIY or Call Us?

You can replace shelf pins, silicone bumpers, and loose knobs without calling anyone. If a door is sagging, you can try a quarter-turn on the hinge adjustment screw, but stop there if the screw spins or the door still won’t hold. The dangerous part of Ameristar cabinet repair isn’t usually the cabinet itself, it’s the countertop sitting on top of it. Removing a base cabinet with quartz or granite still in place can crack the stone or drop the whole run if it’s not properly supported, and that turns a $40 hinge job into a $7,000 countertop replacement. If the problem is a stripped hinge hole, a warped door, or a box pulling off the wall, call us at (877) 610-1318 and we’ll look at it before you touch anything.

FAQs

Call Barrett & Sons Construction

If your Ameristar kitchen needs a part matched, a door rehung, or a whole run rebuilt, call us at (877) 610-1318 for a free estimate. We’ll look at what’s failing, tell you what it costs in writing, and if it’s not done right the first time, we’ll come back and make it right. That’s been our standing promise since 1998, and Tom Barrett still answers for every job.

Written by Tom Barrett, Owner, Barrett & Sons Construction at Barrett & Sons Construction, serving Los Angeles and nearby areas.